Pressure Switches
A pressure switch is a small electronic device that reads the amount of pressure inside of an air tank. When connected to a relay, the compressor will be able to fill the tank automatically. Pressure switches determine the tank pressure at which the compressor starts to run, and when it turns off. The majority of management packages and full kits come with a pressure switch that defaults to turning the compressor on when the tank pressure drops below 110 PSI. When the tank pressure reaches 145 PSI, the compressor will automatically turn off. There are a couple of different options when it comes to pressure switches so if you need some advice on what pressure switch would be best for your system, feel free to contact a Bag Riders air ride specialist for a recommendation!
Pressure Switches Products Browse a collection of Pressure Switches products en
Digital pressure sensors are used to read tank and air spring pressures. This sensor will read from 0psi to 200psi and is commonly found in the following products:
- AccuAir e+ Connect Wireless Controller
- AccuAir e-Level+ System
- AccuAir SwitchSpeed (Tank sensor)
- AccuAir E-Level TouchPad (Tank sensor)
- AccuAir E-Level RockerSwitch (Tank sensor)
- Bag Riders DigiGauge 2 (All 4 bags and tank)
- Zaetech DigiGauge (All 4 bags and tank)
- Air Lift AutoPilot V1 (All 4 bags and tank)
- Pressure Switch Wiring KitPressure Switch Wiring Kit https://www.bagriders.com/media/catalog/product/cache/6cc469ce9f0c45ca88dc49d6594bbebe/p/r/pressure-switch-wiring-kit.jpg$30.00Need to wire up a new pressure switch? Pick up this pressure switch wiring kit to make your life (and the install) a little easier. <br><br> <strong>Includes:</strong> <ul> <li>(1) Non-adjustable Pressure Switch (145PSI)</li> <li>(2) Blue Female Spade Connector (16-14 AWG)</li> <li>(1) Blue Butt Connector (16-14 AWG)</li> <li>(20ft) Red Wire (16 AWG)</li> </ul>BR00657 USD 30.00 https://schema.org/NewCondition https://schema.org/InStock https://www.bagriders.com/air-management/electrical/pressure-switches/pressure-switch-wiring-kit.html
NOTES
- Male 1/8"NPT thread